Connections and control elements
= connection to a speaker, Extender, or Link
= searching for a connection
= no connection
Rear plate – inputs
Input for cable with stereo jack (3.5 mm stereo).
Connect devices here that have an output for the stereo jack.
Input for cable with RCA plug
Connect devices here that have an output for the RCA plug.
NOTE: If a device is connected in parallel at Aux in, only that device will be played back.
Input for optical digital cable (Toslink).
Connect devices here that have an optical digital output.
Input for electrical digital cable (coax).
Connect devices here that have an electrical digital output.
Input for USB cable
Connect your computer’s USB output here. The Hub will then work as a sound card.
Rear plate – other connections and control elements
Intended for future use.
If you assign an ID, you can select the desired Hub from several Hubs using the remote control.
In addition, each ID has its own transmission channel: A = 2.4 GHz, B = 5.2 GHz, C = 5.8 GHz. If the transmission quality is poor or there is a disruption caused by other radio systems, changing to a different channel may produce an improvement.
Connection for power supply unit
Connect the delivered Xeo power supply unit here.
Do not use a different power supply unit!
- Connect the Hub to the mains voltage using the POWER connection and the Xeo power supply unit. Do not use a different power supply unit!
- Connect your signal source to the appropriate input on the Hub.
For a selection of signal sources and options for connecting to the Hub or Connect, see “Connection options for Hub/Connect”.